Chemical Resistance Solvent Resistance Polymer Nylon PA6t Electrical Applications

• Customization: Available
• CAS No.: 25750-23-6
• Molecular Principal Chain: Carbon Chain Polymer
• Model NO.: PA6T
• Type: Polyamide Raw Material Granules
• Material: 100% Nylon
• Grade: Injection Grade
• Application: Building, Automotive, Electronic, Household
• Usage: Injection, General Plastics, Engineering Plastics
• Supply Ability: 800 Metric Tons Per Month
• Certificates: SGS
• Physical Properties: High Chemical Resistance High Mechanical Strength
• Features: Good Oil Resistance Good Impact Toughness
• Transport Package: International Standard Package
• Specification: 20kg/foil bag, 1000kg/carton box
• Trademark: No Mark
• Origin: Shandong, China
• HS Code: 3908101910
• Production Capacity: 10000 Metric Tons Per Year

Product Description

Product Description

 

Nylon 6T is an amorphous nylon resin which exhibits superior transparency, good barrier properties to gases, water, solvents and essentiaoils and high temperature structural properties, which make it suitable for consideration in a number of applications.
 

High heat resistance	With a high glass transition temperature, high rigidity is maintained even in the high temperature environment of the engine room.
Excellent chemical resistance	Demonstrated the best chemical resistance of polyamides.
Small size change caused by water absorption	The size change of water absorption belongs to the lowest category of polyamides, more than 50% lower than PA66.

 

Physical Properties

Typical Characteristics:
 

    √ Smorphous polyamide
    √ Superior transparency
    √ Good barrier properties 
    √ High toughness,high strength
    √ High temperature resistance
    √ Excellent mouldability

 

 

Application

It was widely used in Packacing Indutries

 

1. Blow Moulded Containers

2. Iniection

3. Non Oriented Film

4. Oriented Film

5. Paper Coating

6. Tubes

7. PA6I/6t into Nylon 6 or Nylon 66

8. Textile

 

Our Advantages

 

Injection Molding Reference

Injection molding advice and reference(for reference only):

1) Molding equipment

Equipment needs to consider the situation of wear (flame retardant grade is corrosion resistance).

Select a small device with a single injection volume ≥ 10% of the maximum injection capacity.

A standard nozzle will do.

2) Mold:

Also need to consider the selection of wear (flame retardant grade is corrosion resistant) steel.

The exhaust tank is about 10μm.

3) Prepare for drying

After opening, the product that has been exposed to air (has absorbed water) must be redried.

Dehumidifying dryer: The temperature is 100ºC,2~6h

4) Standard molding conditions

Barrel temperature:

NH 320 (315~335)

C3 320 (320~335)

C2 320 (315~335)

C1 310 (300~325)

Lower hopper :70 (50~ 90)

Mold (non-enhanced grade)120 (90~140)

Injection speed: medium speed

Injection pressure: medium pressure

Screw speed :150rpm